PLATIC AUTO BODY REPAIR

image description

Hot Stabler for Plastic Auto Body Repair
Part No. ML-009

  • Preparing the plastic: Make sure the area to be stabled is free paint and clean. Remove any oils or residues from the plastics surfaces.
  • Getting Started: Plug in control box and turn on .Carefully insert desired staple into one of the three possible positions in the end the stapler without depressing the power button on the handle. Once pressed to the bottom of the hole, the unit is ready for use.
  • Setting the temperature: Turn the control dial to the second or third position, unless very low heat levels are desired. These two positions satisfy most stapling applications.
  • Use: Lay staple over the desired location and apply gentle pressure. Push the button on the handle, then release once the staple is at the desired depth. Allow to cool slightly .Pull back and the staple will remain in the plastic. Clip off the staple with the supplied diagonal cutter.
  • Caution: When clipping off the staple prongs wear eye protection and cup your hand over the staple to prevent the clipped wire from becoming a projectile.

Technical Parameters:
Power Supply: 1ph110V or 230V50/60HZ
Output Voltage: 0.8-1.2 V Packing: Plastic box with cartoon Size: 40 *19*19cm Gross weight: 4.5 kg cable plug style can be ordered.
 

Request For Quote
loader